Assembly
Forum | Topics | Posts | Last post |
---|---|---|---|
No new posts
The windvane is the sensor for change in the (apparent) wind direction.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
The pushrod runs through the vane mast and connects the windvane with the gear axle and ultimately, the pendulum rudder.
Start the assembly with this one, unless you know you will (or think you may) need to mount the windvane at a lower height than standard.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
The Vane mast carries the windvane and shelters the pushrod.
It also allows for the course to be set.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
The vane base is the hub of the windvane self steering system, everything comes together here.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
The pendulum arm carries the pendulum rudder and transfers its swing in to linear movement of the steering lines.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
The vane base is the hub of the windvane self steering system, everything comes together here.
|
3 | 3 | By captain vee 5 years 6 months ago |
No new posts
|
1 | 1 | By captain vee 5 years 11 months ago |
No new posts
The pendulum rudder takes the gentle input from the windvane and turns it in to precise power.
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
|
1 | 1 | By Anonymous 6 years 1 month ago |
No new posts
|
1 | 1 | By Anonymous 6 years 1 month ago |